Cabletron Systems 2M46-04R - Manual (Page 140)

Appendix C: Optional Installations and Mode Switch Bank Settings
C-4 2M46-04R/2M46-04RDC User’s Guide
Figure C-2 2M46-04R Mode Switch Location/Component Layout
Switch definitions and positions are as follows:
• Switches 1 through 4 – For Cabletron Systems use only.
• Switch 5 – COM Port Autobaud. The default (OFF) position enables
Autobaud sensing on the COM port for Local Management sessions.
Changing the switch to the ON position disables Autobaud sensing and
sets the COM port to 9600 baud for Local Management sessions.
• Switch 6 – Forced BootP. Do NOT attempt a Forced BootP unless a
BootP server has been configured for the 2M46-04R. The BootP server
references the location of a station acting as a Trivial File Transfer
Protocol (TFTP) server containing the 2M46-04R image file. When
the position of Switch 6 is changed and the power is cycled to the
2M46-04R, the device requests the image file location from the BootP
server and uses TFTP to download the image from the TFTP server. If
one of these requirements is not met, the 2M46-04R will continue to
request either the BootP server or the TFTP server until the RESET
button on the 2M46-04R is pressed. Once the RESET button is
pressed, the 2M46-04R will reset after one minute and load the image
stored in FLASH memory.
2314-05
Flash
DRAM
MODE SWITCH BANK
1 2 3 4 5 6 7 8
OFF
ON
FRONT PANEL
TOP VIEW WITHOUT COVER
Primary
Power
Supply Redundant
Power
Supply