Cabletron Systems 2M46-04R - Manual (Page 143)

Installing Optional Fast Ethernet Interface Modules
2M46-04R/2M46-04RDC User’s Guide C-7
To install a Fast Ethernet Interface Module in port slot 1 or 2, proceed as
follows:
1. Remove the coverplate from the port slot where the Fast Ethernet
Interface Module will be installed. Refer to
Figure C-4 and proceed as
follows:
a. Remove the two screws fastening the coverplate to the standoffs.
Save the screws.
b. Lift and remove the coverplate from the top of the front standoffs.
NOTE
The installation instructions for the High Speed Interface
Modules are in the associated HSIM user’s guide.
!
CAUTION
The FE-100F3 uses Class 1 lasers. Do not use optical
instruments to view the laser output. The use of optical
instruments to view laser output increases eye hazard. When
viewing the output optical port, power must be removed from
the network adapter.
!
CAUTION
The Fast Ethernet Interface Module and the 2M46-04R are
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
do so could damage the module or the 2M46-04R.
TIP
When installing Fast Ethernet Interface Modules in both port
slots 1 and 2, remove the coverplates from both slot openings.
In the following instructions, the optional module is shown
being installed in port slot 2.