1 changing the com port application, 1 changing the com port application -26, Figure 5-11 – Cabletron Systems 2M46-04R User Manual
Page 74
Chapter 5: Local Management
5-26
2M46-04R/2M46-04RDC User’s Guide
Figure 5-11
COM Port Warning Screen
3.
Use the arrow keys to highlight YES. Press ENTER.
4.
If you ENABLED the port, proceed to step 5. If you DISABLED the
port, use the arrow keys to highlight SAVE at the bottom of the screen,
then press ENTER.
5.
When the message “SAVED OK” appears, the edits you made are
saved.
5.7.10.1 Changing the COM Port Application
After enabling the COM port as described in
, you can
select one of the applications supported by the COM port: LM or UPS.
The default application is LM.
To change the COM port application:
1.
Use the arrows keys to highlight the Application field.
!
CAUTION
Exiting without saving causes the message “NOT SAVED --
PRESS SAVE TO KEEP CHANGES” to appear. Exiting without
saving causes all edits to be lost.
WARNING
174252
THE COM PORT HAS BEEN RECONFIGURED AND THERE IS NO IP
ADDRESS SET FOR THIS DEVICE. YOU WILL NO LONGER BE ABLE
TO MANAGE THIS BOARD. DO YOU STILL WISH TO RECONFIGURE
THIS COM PORT?
YES
NO