Cabletron Systems 2M46-04R User Manual
Page 144
Appendix C: Optional Installations and Mode Switch Bank Settings
C-8
2M46-04R/2M46-04RDC User’s Guide
Figure C-4
Coverplate Removal
2.
Remove the screw from the rear standoff. Save the screw.
3.
. Gently pull the faceplate of the 2M46-04R forward to
allow room for the Fast Ethernet Interface Module to be aligned over
the connector.
4.
Carefully lower the Fast Ethernet Interface Module onto the standoffs
while inserting the module connector into the associated motherboard
connector.
!
CAUTION
When installing an FE-100FX or FE-100F3 module into the
2M46-04R, remove the rubber plug on the module before
proceeding.
!
CAUTION
In the following step, take care when inserting the Fast Ethernet
Interface Module into the motherboard connector, so that the
pins do not bend. Otherwise, the Fast Ethernet Interface Board
and the motherboard could be damaged.
2251-38
Front
Standoffs
Rear
Standoff
Coverplate
1
2
HSIM 1