Rice Lake Static Weighing - Manual (Page 57)

Serial Commands 53
6.1.6 Normal Mode Commands
The normal mode print commands (see Table 6-9) transmit data to the serial port on demand in either setup or
normal mode.
Table 6-9. Normal Mode Serial Commands
Command Description Values
CONSNUM Set consecutive number 0–9 999 999
UID Set unit ID nnnnnnn
SD Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter
six-digit date using the year-month-day order specified
for the DATEFMT parameter, using only the last two digits
of the year.
ST Set time hhmm (enter using 24-hour format)
SX#p Start serial port streaming OK or ??
The port TRIGGE parameter (EDP.TRIGGER#p) for the
streaming port must be set to STREAM before using
these commands.
An EX command sent while in menu mode does not
take effect until the indicator is returned to normal
mode.
EX#p Stop serial port streaming
XG Transmit gross weight in displayed units nnnnnn UU

where nnnnnn is the weight value, UU is the units.
Note
You can also send XGP, XGS, XGT, XTP,
etc. to specify primary, secondary or
tertiary (P.S.T.).
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XA Transmit accululator value
RS Reset system Soft reset. Used to reset the indicator without resetting
the configuration to the factory defaults.
BUFFER Buffer commands Displays on/off status of the buffer
DUMPBUFFER Reads the buffer
CLEARBUFFER Clears the entire buffer
6.1.7 Unique Commands
Table 6-10. Unique Commands
Command Description
EDP.PORT Returns the port you are currently connected to
6.2 Custom Stream Formatting
Each port can be independently configured to stream a default frame format or can be customized to stream a
user-defined format. Custom formatting is very similar to the standard print formatting described in Section 7.0 on
page 56. Table 6-11 lists the format identifiers used to configure a custom stream format.
Format Identifier Defined By Description
STR.POS
STR.NEG Polarity. Specifies positive or negative polarity for the current or
specified (Gross/Net/Tare) weight on the source scale. Possible
values are SPACE, NONE, + (for STR.POS), or – (for STR.NEG)
STR.PRI
STR.SEC
STR.TER Units. Specifies primary, secondary, or tertiary units for the current or
specified weight on the source scale.
Table 6-11. Custom Stream Format Identifiers