Rice Lake Static Weighing - Manual (Page 30)

26 CW-90/90X Checkweigher
Level 4 submenus
TYPE OFF
VAULT
BUFFER Selects the data type as off, VAULT, or Buffer. VAULT (WeighVault; see Section 5.4.3 on
page 45) uses an Ethernet card to access unlimited network ID storage. The buffer can store
approx. 64KB of information, which is 500 transactions using a format with 120 characters of
output.
PORT PORT1
PORT2
PORT3
OFF Specifies the port number for the data type.
TFORMT 12 HOUR
24 HOUR Sets the time format as 12-hour format or 24-hour format.
T SEP COLON
COMMA Sets the time separator as a colon or comma.
SET 000000 Sets the current time.
DFORMT MMDDY4
DDMMY4
Y4MMDD
Y4DDMM
MMDDY2
DDMMY2
Y2MMDD
Y2DDMM Sets the date format. Y4 will use a four-digit year value, such as 2009, while Y2 will use a
two-digit value, such as 09.
D SEP SLASH
DASH
SEMI Sets the date separator as a slash, dash, or semicolon.
SET 000000 Sets the current date.
CALIBR
SETUP
TEST
T&D
ID
ACCUM 0 Sets a password for the Calibrate, Setup, Test, T&D, ID, and Accum menu(s). Specify a
non-zero value to restrict access. Passwords can be overridden by loading new firmware or
entering 999999.
Note
Overriding passwords will clear configuration and calibration settings. To
preserve settings (i.e., ID information), use Revolution software to your data
to a PC, then load it back to the CW-90 after the password override is
performed.
OVER
UNDER
ZERO
UNITS
PRINT
TARE
ID
TARGET
NUMBER UNLOCK
LOCK Locks or unlocks the OVER, UNDER, ZERO, UNITS, PRINT, TARE, ID, TARGET, and numeric
button(s).
FEATUR Menu
Parameter Choices Description
Table 3-5. FEATUR Submenu Parameters (Continued)