Rice Lake Static Weighing - Manual (Page 48)

Note
Note
Note
Note
Note
44 CW-90/90X Checkweigher
6. If in Target mode, TARGET will be displayed. If mode is not set to Target , skip to Step 10. If you do not need
to adjust the value, use the and keys to move to the next parameter. To adjust the value, press Enter
and use the and keys to increment/decrement the values and the and keys to move between
digits. If using the CW-90, you can also use the numeric keypad to enter the desired value.
To discard any changes and return to weigh mode, press the Menu button.

7. When the desired value is displayed, press Enter .

The decimal point flashes.
8. To change the position of the decimal point, use the and keys until it is in the desired position.
9. Press Enter again to accept the value.
10. OVER will be displayed. If you do not need to adjust the value, use the and keys to move to the next
parameter. To adjust the value, press Enter and use the and keys to increment/decrement the values and
the and keys to move between digits. If using the CW-90, you can also use the numeric keypad to
enter the desired value.
To discard any changes and return to weigh mode, press the Menu button.

11. When the desired value is displayed, press Enter . The decimal point flashes.
12. To change the position of the decimal point, use the and keys until it is in the desired position.
13. Press Enter again to accept the value.
14. UNDER will be displayed. Press Enter and use the and keys to increment/decrement the values and the
and keys to move between digits. If using the CW-90, you can also use the numeric keypad to enter
the desired value.
To discard any changes and return to weigh mode, press the Menu button.

15. When the desired value is displayed, press Enter . The decimal point flashes.
16. To change the position of the decimal point, use the and keys until it is in the desired position.
17. Press Enter again to accept the value.
18. TARE will be displayed. Press Enter and use the and keys to increment/decrement the values and the
and keys to move between digits. If using the CW-90, you can also use the numeric keypad to enter the
desired value.
If a tare value is not being entered, press to move to the next parameter.
To discard any changes and return to weigh mode, press the Menu button.

19. When the desired value is displayed, press Enter . The decimal point flashes.
20. To change the position of the decimal point, use the and keys until it is in the desired position.
21. Press Enter again to accept the value.
22. UNITS will be displayed. Press Enter and use the and keys to move between units (LB, OZ, LB/OZ,
OFF, KG, G).
23. When the desired unit is displayed, press Enter .
24. DESC1 will be displayed. If the value does not need adjustment, use the and keys to move to the next
parameter. To adjust the value, press Enter to create an ID description.
25. Use the and keys to increment/decrement description entry characters and the and keys to move
between placeholders.
26. When the desired description is displayed, press the Enter key to accept.
To discard any changes and return to weigh mode, press the Menu button.

27. DESC2 will be displayed. If you do not need to adjust the value, use the and keys to move to the next
parameter. To adjust the value, press Enter to create a secondary ID description. A flashing placeholder is
displayed.
28. Use the and keys to increment/decrement description entry characters and the and keys to move
between placeholders.