Rice Lake Static Weighing - Manual (Page 45)

Note
Operation 41
8. When the desired value is displayed, press Enter .The decimal point flashes.
9. To change the position of the decimal point, use the and keys until it is in the desired position.
10. Press Enter again to accept the value and return to weigh mode.
11. Press the UNDER key. The Under light begins flashing and a flashing digit is shown.
12. Using the and keys to increment/decrement the values and the and keys to move between digits,
enter the desired value. If using the CW-90, you can also use the numeric keypad to enter the desired under
value.
To discard any changes and return to weigh mode, press the Menu button.

13. When the desired value is displayed, press Enter .

The decimal point flashes.
14. To change the position of the decimal point, use the and keys until it is in the desired position.
15. Press Enter again to accept the value and return to weigh mode.
5.2.2 Value Set: Push
1. Place the weight you want to be used as the “target” on the scale.
2. Press the Target key. The Accept light flashes and the indicator displays STORED . The weight has been
captured and stored as the target weight.
3. Press the OVER key. The Over light begins flashing and a flashing digit is shown.
4. Using the and keys to increment/decrement the values and the and keys to move between digits,
enter the desired value. If using the CW-90, you can also use the numeric keypad to enter the desired over
value.
Note
Note
To discard any changes and return to weigh mode, press the Menu button.

5. When the desired value is displayed, press Enter .

The decimal point flashes.
6. To change the position of the decimal point, use the and keys until it is in the desired position.
7. Press Enter again to accept the value and return to weigh mode.
8. Press the UNDER key. The Under light begins flashing and a flashing digit is shown.
9. Using the and keys to increment/decrement the values and the and keys to move between digits,
enter the desired value. If using the CW-90, you can also use the numeric keypad to enter the desired under
value.
To discard any changes and return to weigh mode, press the Menu button.

10. When the desired value is displayed, press Enter . The decimal point flashes.
11. To change the position of the decimal point, use the and keys until it is in the desired position.
12. Press Enter again to accept the value and return to weigh mode.
5.3 Target Percent Mode
In Target Percent mode, the over and under values can only be set by keying in the values (in percentages). The
VALSET parameter only pertains to setting the target weight value. The Accept band is determined based on a
percentage of the desired target weight.
Note
The % annunciator will be lit during target percent setup in menu mode, but not in weigh mode.