QOMO QRF700 User Manual - Manual (Page 131)

1. Under the main menu, Press Down Key or Right Key to select
SETTINGS menu to enter into the Settings submenu.
2. Under the Setting submenu, select “5.DefaultSet” submenu in order to restore
the factory settings.
3. Press the “Menu/OK” key to confirm the operation.
4. Follow the screen prompt, and press the“Del Key” to initialize the setting.
3.1.2.2.9 Student keypad sleep mode
In order to increase the battery life of the response pads, a sleep mode has been
implemented in the student keypad.
To use the sleep mode settings for the student keypad, follow these steps:
1. Under the main menu, Press Down Key or Right Key to select
SETTINGS menu to enter into the Settings submenu.
2.
Under the Hardware submenu, select “3.ScreenSaver” submenu in order to set
the duration time before going to the keypad sleep mode.
3. Press the “Up Key” , Right Key or “Down Key” , Left
Key to increase or decrease the time setting.
4. Press the Menu/ok Key to confirm the setting.
Note: If the clicker stays without any interaction for a period of time that set in Screen
Saver, the clicker will enter into a sleep mode which will shut down the screen’s display.
The user can press any key to wake up the keypad and return to the previous display. For
further saving the battery life, you should turn off the power of the clicker.
3.1.2.2.10 Routine steps using the student keypad

Taking a quiz with the pace controlled by the instructor
Student Keypad Operation Form