QOMO QRF700 User Manual - Manual (Page 130)

5) You may start to work on the questions and save the answers to the keypad and
then submit them the next day in the class; or just save the question frames to
work on them later.
3.1.2.2.8
Student’s keypad special functions
(1) Hardware Test
To use the student keypad for a hardware test, follow these steps:
1. The QClick software must be in the hardware test mode in order to test the
student keypad hardware. Refer to Part 2. Software in session 2.5.3 Hardware
test.
2. Under the main menu, Press Down Key or Right Key to
select HARDWARE TEST menu to enter into the Hardware test screen display.
3.
Enter the channel number, which is the same as the host machine‟s (main
receiver) channel number selected by the PC software.
4. Press the “Menu/OK” key . If the channel number matches the host
receiver channel number, the PC software will dis
play the student‟s keypad ID
on a row in a first come first serve order. Additionally, the register number is also
displayed on the keypad test screen. Otherwise, the failure error message will be
displayed on this test screen.
(2) Student keypad factory settings:
WARNING: Using this function will clear all user data stored, including all the test answers
in this keypad. It is NOT recoverable.
Sometimes it is convenient to clear all data stored in the keypad. This can be done by
simply restoring the factory settings. This is especially useful when you want to trade in
your keypad.
To use the factory settings for the student keypad, follow these steps: