QOMO QRF900 Quick Guide - Manual

Introduction to the QRF900 audience response system
1. Remotes and Dongle
Load two “AA” batteries into the Instructor
(F1-1a) and Student (F1-1b) remotes. Turn on
the Power on the side of the remotes.
2. Start the Software
a. Install QClick software from the CD.
b. Double-click the icon on the desktop to
launch QClick software.
c. Plug in the USB dongle (F1-1c), which
should be automatically recognized by
QClick and go into the login dialog.
d. Enter the default username and password,
both are “qomo”.
Note: If you click Cancel, QClick software
will be in Read-only Mode.
e. QClick toolbar will appear and shows
“QRF900 Connected”. If the toolbar
shows “QRF900 No Host”, try to plug in
the USB dongle again.
3. Setup a Class
a. Click Class icon (F3.1-3a) under Quiz
Genius tab. Click Edit (F3.2-3c) button
next to the Class Name field. Select Add
tab and enter your class name. Click Add
button (F3.2-3d) and Student Settings
window will pop up.
b. In the Student Setting window select ‘Add
New Students’, Enter Student ID, Name,
and any additional information in Student
Profiles window. Click Save to add a
student into the database. Click Close to
complete the settings.
c. Click OK button in Class Settings window.
Class icon (F3.1-3a) will turn to green
when the class is loaded.
Note: If the icon is not green, it means the
class is not loaded properly.