Elecraft KPA100 Manual User Manual
Page 10
10
Picture
Ref. Designator(s)
QTY
Description
Part #
HDWR
2
Fuse, 20A, Littlefuse #312020 or equivalent (1 spare)
E980050
HDWR
2
Jackscrew, 4-40, hex (for J8)
E700078
HDWR
5
Standoff, 3/16 dia. x 3/16" long hex 4-40 thd (between PCB and heat sink)
E700068
HDWR
2
Standoff, 3/16 dia. x 1/2" long hex 4-40 thd (between PCB and shield)
E700061
HDWR
5
Standoff, 3/16 dia. x 5/8" long hex 4-40 thd (between PCB and shield)
E700060
HDWR 20
Screw, 4-40 x 3/16" pan head, black oxide (2 spares)
E700015
HDWR 5
Screw, 4-40 x 3/16" undercut flathead, black oxide (1 spare)
E700025
HDWR
19
Screw, 4-40 x 1/4" panhead (2 spares)
E700005
HDWR
3
Screw, 4-40 x 1/4" flathead (1 spare)
E700063
HDWR
5
Screw, 4-40 x 11/16” flathead
E700199
HDWR
8
Set screw, 4-40 x 1/2", .05" hex socket head, stainless steel (1 spare)
E700066
HDWR
15
Nut, 4-40 small pattern (2 spares)
E700055
HDWR
1
Nut, 6-32 hex, stainless steel (for GND screw)
E700069
HDWR
36
Lock washer, #4 split (3 spares)
E700004
HDWR
2
Flat washer, #6, Stainless Steel
E700067
HDWR
3
Spring clip (used on shield)
Note: Illustration at left shows side and front views of clip.
E980058
HDWR
3
Solder lug (used for grounding J2)
E700062
HDWR
1
Thumbscrew, 6-32 x 1/2", black plastic knob (for GND screw, E1)
E700070
HDWR
5
Fiber washer for speaker, #4, .047" thick x 0.25" dia. (1 spare)
E700028
MISC
1
Heat sink, KPA100, approx. 7.6" W x 6" L (19.23 x 15.2 cm)
E100127
MISC
1
PC board, KPA100
E100134
MISC
1
Top cover trim panel, KPA100, painted (wrapped in paper)
E100135
MISC
1
Rear panel, KPA100, painted and silk-screened (wrapped in paper)
E100136