Control, 8x8 digitalmedia™ switcher crestron dm-md8x8, Edit ctrl sys ip address – Crestron electronic DM-MD8X8 User Manual
Page 38

8x8 DigitalMedia™ Switcher
Crestron DM-MD8X8
Control System IP ID
Edit Ctrl Sys IP Address
[177]
20.
165.
52
Use Softbutton to select.
Then use Knob to edit.
Press ENTER to accept.
• Press the soft button under the octet to be adjusted.
• Turn the selection knob to the desired number.
• Repeat for each octet until the Control System IP Address is displayed.
• To save the Control System IP Address and return to the Network section,
press the ENTER button. To cancel the operation and return to the Network
section, press the MENU button.
MAC Address
The DM-MD8X8 can display its MAC address. To view the MAC address:
• Open the Network section as described on page 29.
• Turn the selection knob to highlight MAC Address and press the ENTER
button to display the MAC Address.
• Press the MENU button to return to the Network section.
Control
The Control section of Installer Tools is used to configure the front panel of the
DM-MD8X8. Any changes made to the Control section will be saved upon exiting
Installer Tools. For more information on exiting Installer Tools, refer to “Exit
Installer Tools” on page 27.
Open Control Section
To open the Control section of Installer Tools:
• Open Installer Tools as described on page 26.
• Turn the selection knob to highlight Control and press the ENTER button.
A list of functions will be displayed.
34
• 8x8 DigitalMedia™ Switcher: DM-MD8X8
Operations Guide – DOC. 6755A