Crestron electronic DM-MD8X8 - Manual (Page 34)

8x8 DigitalMedia™ Switcher Crestron DM-MD8X8
Set IP Address
Edit IP Address
Use Softbutton to select.
The use Knob to edit.
Press ENTER to accept.
[000] 000. 000. 000
• Press the soft button under the octet to be adjusted.
• Turn the selection knob to the desired number.
• Repeat for each octet until the IP address is displayed.
NOTE: Since the DM-MD8X8 reserves a range of IP addresses during
configuration, certain IP addresses cannot be used. Refer to “Ethernet
Setup” on page 20 for more information.
• To save the IP address and return to the Network section, press the ENTER
button. To cancel the operation and return to the Network section, press the
MENU button.
Set the Subnet Mask The DM-MD8X8 can be configured to use a Subnet Mask for TCP/IP
communications. To view or set the address of the Subnet Mask:
• Open the Network section as described on page 29.
• Turn the selection knob to highlight Subnet Mask and press the ENTER
button to display the address of the Subnet Mask. If DHCP is disabled,
controls changing the address will be displayed as shown in the following
diagram.
Set Subnet Mask
Edit Subnet Mask
Use Softbutton to select.
The use Knob to edit.
Press ENTER to accept.
[000] 000. 000. 000
• Press the soft button under the octet to be adjusted.
• Turn the selection knob to the desired number.
• Repeat for each octet until the Subnet Mask address is displayed.
30
• 8x8 DigitalMedia™ Switcher: DM-MD8X8
Operations Guide – DOC. 6755A