Dell B5465dnf Mono Laser Printer MFP - Manual (Page 182)

Use To
Timeouts
Hibernate Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Set the amount of time before the printer enters Hibernate mode.
Note: 3 days is the factory default setting.
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Set the printer to Hibernate Timeout even when there is an active
Ethernet connection.
Note: Hibernate is the factory default setting.
Timeouts
Screen Timeout
15–300
Set the amount of time in seconds the printer waits before
returning to Ready state.
Note: 30 is the factory default setting.
Timeouts
Prolong Screen Timeout
On
Off
Set the printer to continue a specified job without returning to the
home screen when the screen timeout timer expires.
Note: Off is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255
Set the amount of time in seconds the printer waits to receive an
end
‑of‑job message before canceling the rest of the print job.
Notes:
• 90 is the factory default setting.
• When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
• Print Timeout is available only when using PCL emulation.
This has no effect on PostScript emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535
Set the amount of time in seconds the printer waits for more data
before canceling a print job.
Notes:
• 40 is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This has no effect on PCL emulation
print jobs.
Understanding the printer menus 182