Dell B5465dnf Mono Laser Printer MFP - Manual (Page 156)

Use To
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• 8.5 inches is the US factory default setting. You can increase the
width in 0.01
‑inch increments.
• 216 mm is the international factory default setting. You can increase
the width in 1
‑mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US factory default setting. You can increase the
height in 0.01
‑inch increments.
• 356 mm is the international factory default setting. You can increase
the height in 1
‑mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either direction.
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only when the longest edge is shorter than the
maximum width supported in the tray.
Reports Menu
Reports menu
Use To
Menu Settings Page Print a report containing information about the paper loaded in trays, installed
memory, total page count, alarm settings, timeouts, printer control panel
language, TCP/IP address, status of supplies, status of the network connection,
and other information.
Device Statistics Print a report containing printer statistics such as supply information and number
of printed pages.
Network Setup Page Print a report containing information about the network printer settings, such as
the TCP/IP address information.
Note: This menu item appears only in network printers or printers connected
to print servers.
Network [x] Setup Page Print a report containing information about the network settings of the printer,
such as the TCP/IP address information.
Note: This menu item appears only in network printers or printers connected
to print servers, and when there is more than one network option installed.
Understanding the printer menus 156