beautypg.com

Tcp/ip menu – Dell B5465dnf Mono Laser Printer MFP User Manual

Page 160

background image

Use

To

Job Timeout

0, 10–225 seconds

Set the amount of time it takes for a network print job to be canceled.

Notes:

“90 seconds” is the factory default setting.

A setting value of 0 disables the timeout.

If a value between 1 and 9 is selected, then Invalid appears on the
display, and the value is not saved.

Banner Page

Off
On

Allow the printer to print a banner page.

Note: Off is the factory default setting.

TCP/IP menu

To access the menu, navigate to either of the following:

Network/Ports > Standard Network > Standard Network Setup > TCP/IP

Network/Ports > Network [x] > Network [x] Setup > TCP/IP

Note: This menu is available only in network printers or printers attached to print servers.

Use

To

Set Hostname

Set the current TCP/IP host name.

Note: This can be changed only from the Embedded Web Server.

IP Address

View or change the current TCP/IP address.

Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
support BOOTP and RARP.

Netmask

View or change the current TCP/IP netmask.

Gateway

View or change the current TCP/IP gateway.

Enable DHCP

On
Off

Specify the DHCP address and parameter assignment.

Note: On is the factory default setting.

Enable RARP

On
Off

Specify the RARP address assignment setting.

Note: Off is the factory default setting.

Enable BOOTP

On
Off

Specify the BOOTP address assignment setting.

Note: On is the factory default setting.

Enable AutoIP

Yes
No

Specify the Zero Configuration Networking setting.

Note: Yes is the factory default setting.

Enable FTP/TFTP

Yes
No

Enable the built-in FTP server, which lets you send files to the printer using File Transfer
Protocol.

Note: Yes is the factory default setting.

Understanding the printer menus

160