Dell POWEREDGE M1000E - Manual (Page 250)

222 Web Tools Administrator’s Guide
53-1001772-01
SNMP configuration
17
DRAFT: BROCADE CONFIDENTIAL
6. Make the appropriate changes and click OK.
Setting the Switch Policy Authentication mode
This setting determines whether or not authentication is required when a switch logs in to a fabric.
Use the following procedure to set the Switch Policy Authentication mode.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the Security Policies tab.
3. Select Authentication on the Security Policies menu.
4. Use the Switch Policy Authentication Mode option to select the authentication policy.
SNMP configuration
This section describes how to manage the configuration of the SNMP agent in the switch. The
configuration includes SNMPv1 and SNMPv3 configuration, accessControl, and systemGroup
configuration parameters.
Access is read-only if you do not have admin or security admin authority.
For more information, refer to the snmpConfig command in the Fabric OS Command Reference.
Setting SNMP trap levels
Use the following procedure to set SNMP trap levels.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the SNMP tab.
3. Select a trap level for a recipient from the corresponding Trap Level menu in the SNMPv1 and
SNMPv3 sections.
The level you select identifies the minimum event level that prompts a trap.
NOTE
Adding or editing the user name can be done only through the CLI and by selecting a user
name from the User Name menu in the SNMPv3 section.
4. Click Apply.
Changing the systemGroup configuration parameters
Use the following procedure to change the systemGroup configuration parameters.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the SNMP tab.