Dell PowerVault 132T LTO/SDLT (Tape Library) - Manual (Page 43)

Configuring SCSI and Fibre Parameters
SCSI/Fibre allows you to set IDs for the library and drives, configure host access, and set emulation mode. If you have a fibre library, you can set the fibre loop
ID, speed, and topology by means of this menu.
Path:
Set Drive SCSI IDs
The SCSI IDs of the drives identifies which IDs the drives use to communicate with the host.
Step 1 From the Setup menu, highlight
and press .
Step 2 Press and to select IE.
Configures IE slot.
Step 3 Press to move to the next field.
Step 4 Press and to select
configuration option.
Available options are:
l ST: appears as a valid storage location
to the host application (host will see
24 data slots for LTO or 21 for SDLT-
320).
l IE: host will see one import/export slot
and 23 data slots for LTO or 20 for
SDLT-320. If partitioning is enabled,
this slot must be configured "IE" and
not "ST".
Step 5 Press to highlight Run ( ) and
then press .
The IE slot is configured.
Step 6 A confirmation screen displays. Press
to dismiss.
Selection Description/Result
Step 1 From the Setup menu, highlight
and press .
Step 2 Highlight and press .
Sets the drive SCSI IDs.
Step 3 Press and to select the ID you
would like to set for the Drive 1.
You must choose a number between 0 and
15. The default ID is 1.
Step 4 If you have two drives installed,
press to highlight Drive 2.
Step 5 Press and to select the ID you
would like to set for the Drive 2.
You must choose a number between 0 and
15. Ensure that this ID is different from the
ID you set for Drive 1. The default ID is 2.