Dell PowerVault 132T LTO/SDLT (Tape Library) - Manual (Page 35)

Canceling the Setup Wizard
If you do not use the Setup Wizard to configure your library, and do not want to be prompted to use it each time you power up your library, you can cancel it
by following the steps below.
Configuring Your Library With the Setup Wizard
At any time, you can select (return arrow) to exit the Setup Wizard and cancel changes.
Selection Description/Result
Step 1 At the Setup Wizard prompt, press
to select (return arrow).
Cancels the Setup Wizard.
Step 2 You will be prompted to cancel the
Setup Wizard. Press
to select Do Not
Show .
Step 3 Press to highlight Run ( ) and
then press .
The Setup Wizard closes and will not be
shown again at power up. To access the
Setup Wizard, go to the Setup menu.
Selection Description/Result
Step 1 From the Setup menu, highlight
and press .
Runs the Setup Wizard.
Step 2 Press to begin using the
Wizard.
Step 3 Press and to select the
configuration of the IE slot.
Available options are:
l Import/Export: host will see one
import/export slot and 23 data slots for
LTO or 20 data slots for SDLT-320.
l Storage: appears as a valid storage
location to the host application (host will
see 24 data slots for LTO or 21 for SDLT-
320). If partitioning is enabled, this slot
will be in Partition 1.
Step 4 Press and then to accept
the changes and move to the next option.
Step 5 Press and to enable/disable
partitioning.
Available options are:
l on: library is split into two partitions. The
host will be affected (reduced slot/drive
count) based on which partition it is
attached to.
l off: host sees entire library
Step 6 Press and then to accept
the changes and move to the next option.