Dell POWEREDGE M905 - Manual (Page 727)

OSPFv3 Commands 733
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100 seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPFv3 Configuration mode to configure the
external LSDB limit for OSPF. If the value is -1, then there is no limit. When the number of non-
default AS-external-LSAs in a router's link-state database reaches the external LSDB limit, the
router enters overflow state. The router never holds more than the external LSDB limit non-default
ASexternal- LSAs in it database. The external LSDB limit MUST be set identically in all routers
attached to the OSPF backbone and/or any regular OSPF area.
Syntax
external-lsdb-limit limit
no external-lsdb-limit
• limit—External LSDB limit for OSPF (Range: -1-2147483647)
Default Configuration
-1 is the default value for limit.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the external LSDB limit at 100 for OSPF.
console(config)#ipv6 router ospf
console(config-rtr)#external-lsdb-limit 100