Dell POWEREDGE M905 - Manual (Page 401)

QoS Commands 389
1/g5 Down DELL
1/g6 Down DELL
1/g7 Down DELL
1/g8 Down DELL
1/g9 Down DELL
1/g10 Down DELL
traffic-shape
Use the traffic-shape command in Global Configuration mode and Interface Configuration mode
to specify the maximum transmission bandwidth limit for the interface as a whole. This process,
also known as rate shaping, has the effect of smoothing temporary traffic bursts over time so that
the transmitted traffic rate is bounded. To restore the default interface shaping rate value, use the
no form of this command.
Syntax
traffic-shape bw
no traffic-shape
• bw—Maximum transmission bandwidth value expressed in terms of percentage. (Range:
0-100 percentage in increments of 5)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the setting of traffic-shape to a maximum bandwidth of 25.
console(config-if-1/g1)#traffic-shape 25