Ip addressing commands, 1x commands, Ip addressing commands 802.1x commands – Dell POWEREDGE M905 User Manual
Page 55

Command Groups
17
IP Addressing Commands
802.1x Commands
Command
Description
Mode*
clear host
Deletes entries from the host name-to-address cache
PE
helper address
Enable forwarding User Datagram Protocol (UDP)
Broadcast packets received on an interface.
IC
interface out-of-band
Brings up the OOB port configuration menu.
GC
ip address
Sets a management IP address on the switch.
GC
ip address dhcp
Acquires an IP address on an interface from the DHCP
server.
GC
ip address vlan
Sets the management VLAN.
GC
ip default-gateway
Defines a default gateway (router).
GC
ip domain-lookup
Enables IP DNS-based host name-to-address translation.
GC
ip domain-name
Defines a default domain name to complete unqualified
host names.
GC
ip helper address
Allows the device to forward User Datagram Protocol
(UDP) broadcasts received on an interface.
GC
ip host
Configures static host name-to-address mapping in the
host cache.
GC
ip name-server
Configures available name servers.
GC
show arp switch
Displays
the entries in the ARP table.
PE
show hosts
Displays the default domain name, a list of name server
hosts, static and cached list of host names and addresses.
PE
show ip helper address
Displays the ip helper addresses configuration.
PE
show ip interface management
Displays the management IP interface information.
UE
*NOTE:
For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command
Description
Mode*
aaa authentication dot1x
Specifies one or more authentication, authorization and
accounting (AAA) methods for use on interfaces running
IEEE 802.1X.
GC
dot1x max-req
Sets the maximum number of times the switch sends an
EAP-request frame to the client before restarting the
authentication process.
IC