Dell POWEREDGE M905 - Manual (Page 522)

518 VLAN Commands
www
.dell.com | support.dell.com
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays detailed information for unit/port "1/g1."
console#show dvlan-tunnel interface 1/g1
Interface Mode EtherType
--------- ------- --------------
1/g1 Enable vMAN
The following table describes the significant fields shown in the example.
show interfaces switchport
Use the show interfaces switchport command in Privileged EXEC mode to display switchport
configuration.
Syntax
show interfaces switchport {ethernet interface|port-channel port-channel-number}
• Interface—Specific interface, such as ethernet 1/g8.
• port-channel-number—Valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Field Description
Mode This field specifies the administrative mode through which Double
VLAN Tunneling can be enabled or disabled. The default value for this
field is
disabled.
Interface Interface Number.
EtherType This field represents a 2-byte hex EtherType to be used as the first 16
bits of the DVLAN tunnel. The three different EtherType tags are: (1)
802.1Q, which represents the commonly used value of 0x8100. (2)
vMAN, which represents the commonly used value of 0x88A8. (3) If
EtherType is not one of these two values, it is a custom tunnel value,
representing any value in the range of 0 to 65535.