Dell POWEREDGE M905 - Manual (Page 612)

616 IP Routing Commands
www
.dell.com | support.dell.com
Example
The following example defines the IP address and subnet mask for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip netdirbcast
ip route
Use the ip route command in Global Configuration mode to configure a static route. Use the no
form of the command to delete the static route. The IP route command sets a value for the route
preference. Among routes to the same destination, the route with the lowest preference value is the
route entered into the forwarding database. Specifying the preference of a static route controls
whether a static route is more or less preferred than routes from dynamic routing protocols. The
preference also controls whether a static route is more or less preferred than other static routes to
the same destination.
Syntax
ip route ip-address {subnet-mask | prefix-length} next-hop-ip [metric preference]
no ip route ip-address subnet-mask [next-hop-ip] [metric preference]
• ip-address—IP address of destination interface.
• subnet-mask—Subnet mask of destination interface.
• prefix-length—Length of prefix. Must be preceded with a forward slash (/). (Range: 0-32
bits)
• next-hop-ip—IP address of the next hop router.
• preference—Specifies the preference value, a.k.a. administrative distance, of an individual
static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
For the static routes to be visible, you must:
• Enable ip routing globally.
• Enable ip routing for the interface.
• Confirm that the associated link is also up.