Dell POWEREDGE M905 - Manual (Page 389)

QoS Commands 377
Source Layer 4 Port 234
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command in Privileged EXEC mode to display the
current Dot1p (802.1p) priority mapping to internal traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [/|port-channel port-
channel number]
• /—Specifies a valid unit/port combination:
—Physical switch identifier within the stack. Values are 1-12.
— Values are g for gigabit Ethernet port, or xg for 10 gigabit Ethernet port.
—port number. Values are 1-24 or 1-48 in the case of port_type g, and 1-4 for
port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
• port-channel number—Specifies a valid port-channel number. Range is 1-8.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If the interface is specified, the 802.1p mapping table of the interface is displayed. If omitted,
the most recent global configuration settings are displayed.
Example
The following example displays the dot1p traffic class mapping and user priorities.
console#show classofservice dot1p-mapping
User Priority Traffic Class
------------- ---------------
0 1
1 1
2 6
3 4
4 3
5 4
6 5
7 6