Dell POWEREDGE M905 - Manual (Page 655)

Multicast Commands 661
Syntax
ip multicast staticroute sourceipaddr mask rpfipaddr metric vlan vlan-id
no ip multicast staticroute sourceipaddr
• sourceipaddr—IP address of multicast packet source.
• mask—IP mask of multicast packet source.
• rpfipaddr—IP address of next hop toward source.
• metric—Cost of route entry. (Range: 0-255)
• vlan-id—Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example creates a static route which is used to perform RPF checking in
multicast packet forwarding.
console(config)#ip multicast staticroute 224.5.5.5 255.255.255.255
10.1.1.1 5 vlan 15
ip multicast ttl-threshold
Use the ip multicast ttl-threshold command in Interface Configuration mode to apply a ttlvalue
to a routing interface. ttlvalue is the TTL threshold which is applied to the multicast Data packets
forwarded through the interface.
Syntax
ip multicast ttl-threshold ttlvalue
no ip multicast ttl-threshold ttlvalue
• ttlvalue—Specifies TTL threshold. (Range: 0-255)
Default Configuration
This command has no default configuration.