Dell POWEREDGE M905 - Manual (Page 337)

802.1x Commands 321
Syntax
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
• seconds — Time in seconds that the switch waits for a response from the authentication
server. (Range: 1 - 65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The actual timeout is this parameter or the product of the Radius transmission times the
Radius timeout, whichever is smaller
Example
The following example sets the time for the retransmission to the authentication server to
3600 seconds.
console(config-if-1/g1)# dot1x timeout server-timeout 3600
dot1x timeout supp-timeout
Use the dot1x timeout supp-timeout command in Interface Configuration mode to set the time
that the switch waits for a response before retransmitting an Extensible Authentication Protocol
(EAP)-request frame to the client. To return to the default setting, use the no form of this
command.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
• seconds — Time in seconds that the switch should wait for a response to an EAP-request
frame from the client before resending the request. (Range: 1 - 65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode