Dell POWEREDGE M905 - Manual (Page 66)

28 Command Groups
www
.dell.com | support.dell.com
TACACS+ Commands
Telnet Server Commands
VLAN Commands
Command Description Mode*
key Specifies the authentication and encryption key for all
TACACS communications between the device and the
TACACS server. TC
port Specifies a server port number. TC
priority Specifies the order in which servers are used. TC
show tacacs Displays TACACS+ server settings and statistics. PE
tacacs-server host Specifies a TACACS+ server host. GC
tacacs-server key Sets the authentication and encryption key for all
TACACS+ communications between the switch and the
TACACS+ daemon. GC
tacacs-server timeout Sets the interval for which the switch waits for a server host
to reply. GC
timeout Specifies the timeout value in seconds. TC
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
ip telnet server disable Enables/disables the Telnet service on the switch. GC
ip telnet port Configures the Telnet service port number on the switch. GC
show ip telnet Displays the status of the Telnet server and the Telnet
service port number. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
dvlan-tunnel ethertype Configures the EtherType for the interface. GC
interface vlan Enters the interface configuration (VLAN) mode. GC
interface range vlan Enters the interface configuration mode to configure
multiple VLANs. GC
mode dvlan-tunnel Enables Double VLAN tunneling on the specified interface IC