Dell POWEREDGE M905 - Manual (Page 713)

OSPFv3 Commands 719
OSPFv3 Commands
area default-cost
Use the area default-cost command in Router OSPFv3 Configuration mode to configure the
monetary default cost for the stub area. The operator must specify the area id and an integer value
between 1-16777215. Use the no form of the command to return the cost to the default value.
Syntax
area areaid default-cost cost
no area areaid default-cost
• areaid—Valid area identifier.
• cost—Default cost. (Range: 1-16777215)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the monetary default cost at 100 for stub area 1.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 default-cost 100
area nssa
Use the area nssa command in Router OSPFv3 Configuration mode to configure the specified
areaid to function as an NSSA.