Dell POWEREDGE M905 - Manual (Page 451)

Port Channel Commands 443
User Guidelines
Commands in the interface range context are executed independently on each interface in
the range. If the command returns an error on one of the interfaces, it stops the execution of
the command on subsequent interfaces.
Example
The following example shows how port-channels 1, 2 and 8 are grouped to receive the same
command.
console(config)# interface range port-channel 1-2,8
console(config-if)#
hashing-mode
Use the hashing-mode command to set the hashing algorithm on trunk ports.
Syntax
hashing-mode mode
• mode—Mode value in the range of 1 to 6.
Range: 1–6:
1. Source MAC, VLAN, EtherType, source module, and port ID
2. Destination MAC, VLAN, EtherType, source module, and port ID
3. Source IP and source TCP/UDP port
4. Destination IP and destination TCP/UDP port
5. Source/destination MAC, VLAN, EtherType, and source MODID/port
6. Source/destination IP and source/destination TCP/UDP port
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (port-channel)
User Guidelines
No specific guidelines.
Example
console(config)#interface port-channel l