Dell POWEREDGE M905 - Manual (Page 327)

IP Addressing Commands 309
Example
The following example defines a static host name-to-address mapping in the host cache.
console(config)#ip host accounting.dell.com 176.10.23.1
ip name-server
Use the ip name-server command in Global Configuration mode to define available name servers.
To delete a name server, use the no form of this command.
Syntax
ip name-server server-address1 [server-address2 … server-address8]
no ip name-server [server-address1 … server-address8]
• server-address—Valid IP addresses of the name server. (Range: 1 - 255 characters)
Default Configuration
No name server IP addresses are specified.
Command Mode
Global Configuration mode
User Guidelines
Server preference is determined by entry order.
Up to eight servers can be defined in one command or by using multiple commands.
Example
The following example sets the available name server.
console(config)#ip name-server 176.16.1.18
show arp switch
Use the show arp switch command in Privileged EXEC mode to display the entries in the ARP
table used by the management interface.
Syntax
show arp switch
Default Configuration
This command has no default configuration.