Dell POWEREDGE M905 - Manual (Page 671)

OSPF Commands 677
• non-comparable—A metric type of nssa-external 2
Default Configuration
If no metric is defined, 10 is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the metric value and type for the default route advertised
into the NSSA.
console(config-router)#area 20 nssa default-info-originate 250
non-comparable
area nssa no-redistribute
Use the area nssa no-redistribute command in Router OSPF Configuration mode to configure the
NSSA Area Border router (ABR) so that learned external routes are not redistributed to the NSSA.
Syntax
area area-id nssa no-redistribute
no area area-id nssa no-redistribute
• area-id—Identifies the OSPF NSSA to configure. (Range: IP address or decimal from 0-
4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the NSSA ABR.
console(config-router)#area 20 nssa no-redistribute