Dell POWEREDGE M905 - Manual (Page 721)

OSPFv3 Commands 727
area virtual-link dead-interval
Use the area virtual-link dead-interval command in Router OSPFv3 Configuration mode to
configure the dead interval for the OSPF virtual interface on the virtual interface identified by
areaid and neighbor.
Syntax
area areaid virtual-link neighbor dead-interval seconds
no area areaid virtual-link neighbor dead-interval
• areaid—Valid OSPFv3 area identifier.
• neighbor—Router ID of neighbor.
• seconds—Dead interval. (Range: 1-65535)
Default Configuration
40 is the default value for seconds.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a 20-second dead interval for the OSPF virtual interface on
the virtual interface identified by area 1 and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 dead-interval 20
area virtual-link hello-interval
Use the area virtual-link hello-interval command in Router OSPFv3 Configuration mode to
configure the hello interval for the OSPF virtual interface on the virtual interface identified by
areaid and neighbor.
Syntax
area areaid virtual-link neighbor hello-interval seconds
no area areaid virtual-link neighbor hello-interval
• areaid—Valid OSPFv3 area identifier.
• neighbor—Router ID of neighbor.