Telnet or ssh sessions, Rules for telnet connections, Table 2 – Dell POWEREDGE M1000E User Manual
Page 57
Fabric OS Administrator’s Guide
57
53-1002745-02
Fabric OS command line interface
2
•
In a Windows environment enter the following parameters:
•
In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, use ttya instead and enter the following string at the prompt:
tip /dev/ttya -9600
Telnet or SSH sessions
You can connect to the Fabric OS through a Telnet or SSH connection or by using a console session
on the serial port. The switch must also be physically connected to the network. If the switch
network interface is not configured or the switch has been disconnected from the network, use a
console session on the serial port as described in
“Console sessions using the serial port”
NOTE
To automatically configure the network interface on a DHCP-enabled switch, plug the switch into the
network and power it on. The DHCP client automatically gets the IP and gateway addresses from the
DHCP server. The DHCP server must be on the same subnet as the switch. Refer to
Rules for Telnet connections
The following rules must be observed when making Telnet connections to your switch:
•
Never change the IP address of the switch while two Telnet sessions are active; if you do, your
next attempt to log in fails. To recover, gain access to the switch by one of these methods:
-
You can use Web Tools to perform a fast boot. When the switch comes up, the Telnet quota
is cleared. (For instructions on performing a fast boot with Web Tools, see the Web Tools
Administrator’s Guide.)
-
If you have the required privileges, you can connect through the serial port, log in as
admin, and use the killTelnet command to identify and kill the Telnet processes without
disrupting the fabric.
•
For accounts with an admin role, Fabric OS limits the number of simultaneous Telnet sessions
per switch to two. For more details on session limits, refer to
TABLE 2
Terminal port parameters
Parameter
Value
Bits per second
9600
Databits
8
Parity
None
Stop bits
1
Flow control
None