Dell POWEREDGE M1000E - Manual (Page 408)

408 Fabric OS Administrator’s Guide
53-1002745-02
Encryption and compression examples
14
Are you done? (yes, y, no, n): [no] y
Saving data to key store... Done.
myswitch:admin> secauthsecret --show
WWN
DId Name
-----------------------------------------------
10:00:00:05:1e:e5:cb:00
150 dcx_150
myswitch:admin>
Activate authentication
After you set up the DH-CHAP secrets, you activate DH-CHAP authentication.
myswitch:admin> authutil --policy -sw active
Warning: Activating the authentication policy requires either DH-CHAP secrets or
PKI certificates depending on the protocol selected. Otherwise, ISLs will be
segmented during next E-port bring-up.
ARE YOU SURE (yes, y, no, n): [no] y
Auth Policy is set to ON
myswitch:admin> authutil --show
AUTH TYPE
HASH TYPE GROUP TYPE
--------------------------------------
dhchap
md5 4
Switch Authentication Policy: ON
Device Authentication Policy: OFF
myswitch:admin>
Enabling encryption
Next, you enable encryption on port 0. Note that the first attempt fails because the port is currently
enabled. This example uses the portCfgShow command to check the result. Notice that the output
shows encryption to be enabled on the port.
myswitch:admin> portcfgencrypt --enable 0
Please disable port to configure Encryption/Compression.
myswitch:admin> portdisable 0
myswitch:admin> portcfgencrypt --enable 0
Turning ON Encryption on port(246) will cause the port to be disabled during next
LOGIN
myswitch:admin> portenable 0
myswitch:admin> portcfgshow 0
Area Number:
0
Octet Speed Combo: 3(16G,10G)
Speed Level: AUTO(SW)
AL_PA Offset 13: OFF
Trunk Port ON
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
Locked E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
LOS TOV enable OFF
NPIV capability ON
QOS E_Port AE
Port Auto Disable: OFF