Dell POWEREDGE M1000E User Manual
Page 428
428
Fabric OS Administrator’s Guide
53-1002745-02
Configuring FA-PWWNs
16
3. Enter the fapwwn --show -ag all command:
You should see output similar to the following sample. (In this example, long lines of output are
shown split across two lines, for better readability.)
-----------------------------------------------------------
AG Port
Port
Device Port WWN
\
-----------------------------------------------------------
10:00:00:05:1e:65:8a:d5/16
--
--:--:--:--:--:--:--:--
\
10:00:00:05:1e:d7:3d:dc/8
20
20:08:00:05:1e:d7:2b:74
\
\
10:00:00:05:1e:d7:3d:dc/9
20
20:09:00:05:1e:d7:2b:73
\
10:00:00:05:1e:d7:3d:dc/16
--
--:--:--:--:--:--:--:-- \
------------------------------------------------------------
Virtual Port WWN
PID
Enable MapType
------------------------------------------------------------
52:00:10:00:00:0f:50:30
--
Yes
AG/Auto
11:22:33:44:55:66:77:88
11403
Yes
AG/User
52:00:10:00:00:0f:50:32
2:00:10:00:00:0f:50:33
11404
Yes
AG/Auto
52:00:10:00:00:0f:50:38
--
Yes
AG/Auto
4. Enable the FA-PWWN on the HBA. The following steps are to be executed on the server and not
the switch.
a. Log in to the server as root.
b. Enter the following command:
bcu port -faa port_id --enable
c. Enter the following command:
bcu port -faa port_id --query
Once the Brocade HBA has been assigned the FA-PWWN, the HBA retains the FA-PWWN until
rebooted. This means you cannot unplug and plug the cable into a different port on the Access
Gateway. You must reboot the HBA before moving the HBA to a different port. If you move an HBA to
a different port on a switch running Fabric OS v7.0.0 or later, the HBA will disable its port. If the HBA
moves to a different port on a switch running a version of Fabric OS earlier than 7.0.0, the HBA will
continue to disable its port.
Configuring an FA-PWWN for an HBA connected to an edge switch
For this procedure, some of the steps are to be executed on the switch and some are to be
executed on the server.
1. Log in to the edge switch to which the device is connected.
2. Assign the FA-PWWN.
•
If you are manually assigning a WWN, enter the following command:
fapwwn --assign -port [slot/]port -v Virtual_PWWN
•
If you want the WWN to be automatically assigned, enter the following command:
fapwwn --assign -port [slot/]port