ClearOne XAP400 - Manual (Page 24)

Installation ~ LCD Programming 18
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
TERLE
This submenu allows you to monitor the TERLE meter on the XAP 400. Press Enter
to enable your selection.
Default Meter
This submenu determines what is displayed on the LED meter when a meter is not
specifically selected elsewhere in the Meter menu. The default is Output 8.
The Meter Reference Point diagram on following page shows where the meter
pick-up points ( ) are in the signal path through the XAP 400.
Inputs menu
There are two submenus under the Inputs menu: Mute and Gain. To access these
submenus you must first select the input. Choose from Inputs 1—8, Global, or From
Telco. Use the and buttons to select the Inputs menu, then scroll through the
options and press Enter when you reach the desired option.
Mute
This submenu allows you to turn mute on or off (default) for the selected input.
Gain
This submenu allows you to adjust the gain for the selected input. Use the and
buttons to increase or decrease gain.
Outputs menu
There are two submenus under the Outputs menu: Mute and Gain. To access these
submenus you must first select the output. Choose from Outputs 1—8, Speaker, or To
Telco. Use the and buttons to select the Outputs menu, then scroll through the
options and press Enter when you reach the desired option.
Mute
This submenu allows you to turn mute on or off (default) for the selected output.
Gain
This submenu allows you to adjust the gain for the selected output. Use the and
buttons to increase or decrease gain.