ClearOne XAP400 - Manual (Page 113)

107
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
XAP 400 Serial commands
Command Function
AA Sets auto-answer for a telco channel
AAMB Selects/reports adapt ambient setting
ACONN Sets the audible connect signal to on/off
ACONNLVL Sets the level of the audible connect signal
AD Sets auto-disconnect for a telco channel
AEC Selects/reports acoustic echo canceller setting
AGC Enable/disables AGC
AGCSET Selects/reports AGC settings on inputs
ALC Sets the ALC for the telco receive
AMBLVL Selects/reports ambient level
BAUD Selects/reports the baud rate of the serial port
CGROUP Selects/reports compressor group setting
CHAIRO Selects/reports chairman override setting
COMPRESS Sets/reports compressor on audio processing
channel
COMPSEL Selects/reports compressor activity for
processor
COUNTRY Sets/reports the country for compliance
DECAY Sets/reports decay rate
DELAY Sets/reports delay rate
DELAYSEL Selects/reports processor channel delay
DFLTM Sets/reports default meter
DIAL Dials a DTMF sequence or reports last
sequence dialed
DID Selects/reports device ID
DSPVER Reports DSP firmware version
DTMFLVL Sets the DTMF tone level in the room
DTONELVL Selects/reports the audible dial tone level
FILTER Selects/reports input/processor channel filter
setting
FILTSEL Enables/disables filters on input/processor
channel
FLOW Selects/reports the flow control of the serial
port
FMP Sets/reports 1st Mic Priority for mic gating
group
FPP Sets/reports current passcode setting
GAIN Changes/reports gain for in, out, or process.
Command Function
GATE Reports gate status of channels 1—4
GHOLD Selects/reports hold time setting
GMODE Selects/reports gating mode setting
GOVER Selects/reports gating override setting
GRATIO Selects/reports gate ratio setting
GREPORT Selects/reports gate status report frequency
GRPSEL Selects/reports input gating group assignments
HOOK Sends a hook flash to the telephone line
HOOKD Sets hook flash duration
LABEL Selects/reports label of specified channel
LFP Sets/reports status of front panel access
LOCK Selects/reports the state of the preset and
macro lock. When on, the lock prevents presets
and macros that have been flagged from being
altered in any way.
LOCKPRST Selects/reports whether the lock is applied to a
preset or macro. If a preset or macro has the
lock applied, it can only be changed if the unit
is unlocked with the password.
LOCKPWD Selects/reports the password for the
preset/macro lock. This can only be changed if
the unit is unlocked.
LMO Selects/reports Last Mic On mode
LVL Reports in, out, or processor level
LVLREPORT Selects/reports level status
LVLRRATE
Sets the level report rate for the unit
MACRO Executes macro or reports last macro
executed
MASTER Reports the mode of the unit
MAX Changes/reports max gain setting for in, out,
processor block
MDMODE Enables/disables the modem mode for the unit
MIN Changes/reports minimum gain setting for in,
out, processor block
MINIT Sets/reports modem initialization string of
serial port
MINMAX Changes/reports min and max gain from in,
out, processor block
Appendices ~ Appendix E: Serial Commands