ClearOne Converge Pro - Manual (Page 45)

40
CONNECT Cobranet/AVB Connections and Controls
Refer to the following diagrams and descriptions for CONNECT CobraNet/AVB connections and controls.
CONNECT CobraNet and CONNECT AVB Connections
Set each CONNECT CobraNet and CONNECT AVB unit to a unique ID using the Device ID selector rotary switch
on the back of the unit. (Range 0-7) Each CONNECT unit in any site needs a unique Device ID. Only 8 units are
allowed in any site.
Ethernet LAN
Network 1
CONVERGE Pro/SR
CONNECT
Network Bridge
CONNECT
Network Bridge
Ethernet LAN
Network 2
CobraNet
CONNECT
Network Bridge
CONNECT
Network Bridge
Connecting CONVERGE Pro/SR units in different
rooms that are on different networks using
multiple CobraNet and AVB network bridges
AVB
CobraNet
AVB AVB
CobraNet
Link IN
Link IN
Link OUT
Link IN
Link IN
AVB
Network
Connection
AVB
Network
Connection
CobraNet
Network
Connection
CobraNet
Network
Connection
CONVERGE Pro/SR
CONVERGE Pro/SR
Device ID
Switch
E-bus LINK IN from Stack
E-bus LINK OUT
(Not required if the bridge
is at the end of the stack)
Bridge connection
to Ethernet Network
(CobraNet shown)
5V DC
Power
Input
CONNECT CobraNet and CONNECT AVB Control
The CONNECT CobraNet and the CONNECT AVB network audio bridges are controlled mainly through
CONVERGE Console where configuration is made and device identification (set matching the Device ID switch) is
established in the stack.