ClearOne Converge Pro - Manual (Page 354)

349
CONVERGE PRO 8I
Audio Performance
• Conditions: Unless otherwise specified, all
measurements are performed with a 20 Hz to 22 kHz
BW limit (no weighting)
• Frequency Response: 20 Hz to 22 kHz ±1dB
• Noise (EIN): -126 dBu, 20 kHz BW, max gain,
• Rs=150 Ω
• THD+N: <0.02%
• Dynamic Range: >100 dB (non A-weighted)
• Crosstalk <-91 dB re 20 dBu @ 20 kHz channel to
channel
Auto Mixer Features
• Number of Open Microphones (NOM)
• PA Adaptive Mode
• First Mic Priority Mode
• Last Mic Mode
• Maximum # of Mics Mode
• Ambient Level
• Gate Threshold Adjust
• Off Attenuation Adjust
• Hold Time
• Decay Rate
Matrix Mixing Features
• 36x24 matrix
• 12 analog in/out
• 12 expansion bus in/out
• 8 assignable processing blocks in/out
• 4 assignable fader blocks in/out
Assignable Processing Blocks
• Filters
» All pass
» Low pass
» High pass
» Low shelving
» High shelving
» Parametric EQ
» Notch
» CD Horn
• Crossovers
» Bessel
» Butterworth
» Linkwitz-Riley
• Compressor
• Delay; adjustable up to 250 ms
Assignable Fader Blocks
• Gain/Mute
Microphone Input Configuration
• Input Gain Adjust
• Mic or Line Level
• Phantom Power on/off
• Echo Cancellation on/off
• Noise Cancellation on/off
• Filters
» All Pass
» Low Pass
» High Pass
» Notch
» PEQ
• Mute on/off
• Chairman Override on/off
• AGC on/off
• Automatic Level Control on/off
• Auto Gate/Manual gate
• Adaptive Ambient on/off
• Pre AEC channel
Mic/Line Inputs 1-8
• Push-on mini-terminal block, balanced, bridging
• Impedance: < 10 KΩ
• Nominal Level: adjustable -56 dBu to 0 dBu (7 dB step
coarse gain adjustment)
• Maximum Level: -65 dBu to +20 dBu
• Echo Cancellation: 130 ms tail time (works with 12 dB
of room gain)
• Noise Cancellation: 6–15 dB attenuation
• Phantom Power: 24 V, selectable
Line Inputs 9-12
• Push-on mini-terminal block, balanced, bridging
• Impedance: < 10 KΩ
• Nominal Level: 0 dBu
• Maximum Level: 20 dBu
Expansion Bus In/Out
• Proprietary Network
• RJ-45 (2), 1.9 Mbps
• CAT-5 twisted-pair cable, 200’ maximum cable length
Ethernet
• Autoswitching with Quality of Connection (QoC)
• 10/100 Mbps Ethernet Network Port
• 10/100 Mbps Ethernet PC Port
• RJ-45 Connectors
RS-232
• Serial Command Protocol Only (Console software not
supported on RS-232 port)
• DB-9 female
• 9,600/19,200/38,400/57,600/115,200 baud rate; 8 bits,
1 stop bit, no parity
• Hardware flow control on (default)/off
USB
• Version 2.0 compatible
• Type B connector
Control/Status Ports
• DB-25 female A/B (2)
• Inputs A/B: active low (pull to ground)
• Outputs A/B: open collector, 40 VDC max, 40 mA each
• +3.3 VDC pins (2) (300 mA over-current protected)
Configuration & Administration Software
• Converge Console
Power Input Range
• Auto-Adjusting
• 100–240 VAC; 50/60 Hz
Power Consumption
• 30 W Typical
Dimensions (L x D x H)
• 17.25” x 10.25” x 1.75”
• 43.8 x 26 x 4.5 cm