ClearOne Converge Pro - Manual (Page 278)

273
DFLTM – Default Meter
This command selects/reports the setting of the default meter on the front panel.
Command Form : DEVICE DFLTM [Channel Group Position]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels
(Null to query in text)
-
Group Group 1 1, 2, 3, 7, 16, 17 (I, O, M, L, T, R) -
Position Meter Type 2 1 – 4, as applicable for group
See
Meter Type Definitions
-
DIAG – Diagnostic Commands
This command is used to return status and diagnostic information. It is intended to be used as a text command
only. This is a query only command.
Command Form : DEVICE DIAG [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 23 (J) -
Value Unsigned
Short 2 0 = List of current commands
(J) Power Amp
1 = Fan/Temp
2 = Noise Gate
3 = Feedback Nodes
-
Information String 80 Diagnostic String
(ALWAYS NULL IN TEXT)
-
DIAL – DTMF Dialing
This command dials a DTMF sequence or reports back the last sequence dialed.
Command Form : DEVICE DIAL [Number]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 17 (R) -
Reserved 2 0 -
Number String 40 1 – 40 Chars of ‘0’ – ‘9’, ‘*’, ‘#’, ‘,’
(Null to query last number dialed in text)
-
DID – Device ID
This command reports the device id. This command is read only except through the front panel.
Command Form : DEVICE DID [Value]
Argument Type Size Values Units
Value Unsigned Integer 4 See Type And Device IDs
(Null sent in text, Value returned)
-
DTMFLVL – DTMF Tone Level
This command selects/reports the DTMF tone level.
Command Form : DEVICE DTMFLVL [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 17 (R) -
Value Signed Float 2 -12.00 – 12.00
(Null to query in text)
dB