ClearOne Impress IM100 User Manual - Manual (Page 9)

U
SER
M
anUal
7
C
OnnECt wIth an
E
nCODER
The IMPRESS unit supports two types of output connections as shown below:
The IMPRESS unit in most cases will be connected with a StreamNet Encoder MLAV9300 or
MLAV9500-CS, with the encoded data decoded by a VL9300-CS or VL9100 decoder. In these
situations The IMPRESS unit will be used as one of the sources for a StreamNet system. For more
detail, see the StreamNet Setup chapter.
The following table shows the format and resolutions of each device:.
» NOTE: All outputs are at 60 Hz, vertical.
The following diagram is an example of a typical network setup:
C
OnnECt thE
C
OntROl
K
EybOaRD
The IMPRESS is controlled by a small keypad. Connect this keypad to a USB connector on the front
or back of the player.
Encoders Decoders
Format Resolutions MLAV9500-CS MLAV9300 VL9300-CS VL9100
800x600 Yes Yes Yes Yes
4:3
1024x768 Yes Yes Yes Yes
1280x720 Yes No Yes Yes
1280x768 Yes Yes Yes Yes
1376x768 No Yes Yes Yes
16:9
1920x1080 Yes No Yes No