ClearOne Impress IM100 User Manual - Manual (Page 19)

U
SER
M
anUal
17
To configure the MediaLinX for use with the IMPRESS, set the following:
1. Source Type
In the Source tab, set the Source Type to “ClearOne Impress.” The Driver File will automatically
select “Impress.lua.”
SOURCE CONFIGURATION
The MLAV9300 or MLAV9500-CS encoder being used to interface the IM100 to the StreamNet
network must have the correct Driver File, Source Type, IMPRESS IP Address and IMPRESS
Password defined. Verify the configuration information on the tabs for the device as shown in the
following screen examples The following screen is shows the Source tab for a MediaLinX given a
Source Name of IMPRESS.