ClearOne Impress IM100 User Manual - Manual (Page 16)

14 t
EChnICal
S
UPPORt
: 800.283.5936
V
ERIfyIng thE
n
EtwORK
S
EtUP
Once the IMPRESS networking hardware has been connected and its settings have been configured,
your Network Administrator should verify that the network is operating properly.
To verify that data can reach the IMPRESS IM100 unit, use a PC on the same network. Open a Com-
mand prompt on the PC, then type in a “ping” command:
ping x.x.x.x
Substitute your IP address for the “x.x.x.x” shown above. For example, if the IP address of your
IMPRESS unit is “10.1.1.4”, then you should type:
ping 10.1.1.4
If your network connection is successful, you should see results similar to the following:
C:\Windows>ping 10.1.1.4
Pinging 10.1.1.4 with 32 bytes of data:
Reply from 10.1.1.4: bytes=32 time<10ms TTL=255
Reply from 10.1.1.4: bytes=32 time<10ms TTL=255
Reply from 10.1.1.4: bytes=32 time<10ms TTL=255
Reply from 10.1.1.4: bytes=32 time<10ms TTL=255
Reply from 10.1.1.4: bytes=32 time<10ms TTL=255
Ping Statistics for 10.1.1.4:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss).
If a connection cannot be established between the IMPRESS and your networked PC, you should
repeat the hardware and software setup steps, verifying your settings. Pay particular attention to
the IP address and Subnet value.
If the above test still fails, have your Network Administrator contact ClearOne.