ClearOne Impress IM100 User Manual - Manual (Page 28)

26 t
EChnICal
S
UPPORt
: 800.283.5936
The IMPRESS can be password protected to prevent unauthorized users from publishing to it. The
Password section allows you to have the password sent automatically. Note that the password is
actually set elsewhere (discussed at the end of this section), this field is used only to eliminate the
need to type in the password every time you publish. Your password is defined on the Sites tab of
the setup dialog.
The Project to Publish section allows you to select a project file to always publish to this site. This
will save you a step at publish time, but only if you always use the same file.
Connection Method
Depending on the way each IMPRESS unit is connected, there are different ways to set up each
site description.
Click on the Connection Method tab and then select one of the following four types:
TCP/IP - The “Network” publish method is for IMPRESS units that are connected to your corporate
LAN or to the Internet.
Enter the IP address of the unit. This must be the same address that has been programmed into
the IMPRESS unit at setup time. If you do not know this address, obtain it from your Network
Administrator.
When publishing, IMPRESS Composer will automatically connect to the IMPRESS unit across the
network and send your project’s pages.
Direct Serial Connection - The serial publish method is for IMPRESS units connected directly to
your PC via a serial cable. Select the “COM” port that corresponds with the cable connection.
At publish time, IMPRESS Composer will automatically connect with the IMPRESS unit and send
over the pages of your project.