ClearOne Impress IM100 User Manual - Manual (Page 8)

6 t
EChnICal
S
UPPORt
: 800.283.5936
IMPRESS Installation
BOX CONTENTS
Before you begin setup of your IMPRESS unit, make sure the following components are included
in the original packaging:
• IMPRESS IM100 Main System Unit
• Control Keypad
• Power Cord
• Null Modem Serial Cable
• IMPRESS Composer CD-ROM
• 1/8” Audio Cable
• User Manual CD
HARDWARE INSTALLATION
The IMPRESS IM100 chassis is a 1RU, 1/2 rack solution. Ideally, it will be installed in a rack mount
case or cabinet in a climate-controlled room. The height of the unit is less than 1RU to allow for
airflow requirements.
If a rack mount installation is not available, the IMPRESS unit should be placed on a stable, flat,
level surface.
Take care to ensure the unit is not placed where it may be easily knocked over, have its cords
tripped over, or have liquids spilled into it.
The IMPRESS unit warranty does not cover damage caused by accidents or misuse.
All of the connections are found on the rear panel, shown below.
» NOTE: You must unplug the IMPRESS before adding or changing any connections.
Failure to do so may damage your IMPRESS unit.