Metrohm 794 Basic Titrino - Manual (Page 103)

3.2 Remote control commands
794 Basic Titrino
99
&Setup
Object Description Input range Reference
& Root
:
├ Setup Settings for the operating mode
├ .Keycode Send key code ON, OFF 3.2.2.88.
├ .Tree Sending format of path info
│ ├ .Short Short format of path ON, OFF 3.2.2.89.
│ ├ .ChangedOnly Paths of modified nodes only ON, OFF ditto
│
├ .Trace Message on changed values ON, OFF 3.2.2.90.
│
├ .Lock Lock key functions
│ ├ .Keyboard Lock all keyboard keys ON, OFF 3.2.2.91.
│ ├ .Config Lock key ON, OFF ditto
│ ├ .Parameter Lock key ON, OFF ditto
│ ├ .SmplData Lock key ON, OFF ditto
│ ├ .UserMeth Lock functions
│ │ ├ .Recall Lock “loading” ON, OFF ditto
│ │ ├ .Store Lock “saving” ON, OFF ditto
│ │ ├ .Delete Lock “deletion” ON, OFF ditto
│ └ .Display Lock display function ON, OFF ditto
│
├ .Mode Setting waiting intervals
│ ├ .StartWait Waiting time after start ON, OFF 3.2.2.92.
│ ├ .FinWait Waiting time after run ON, OFF ditto
│
├ .SendMeas Automatic sending of measured values
│ ├ .SendStatus Connect/disconnect sending ON, OFF 3.2.2.93.
│ ├ .Interval Time interval 0.08...4...16200, ditto
│
MPList
│ ├ .Select Selection Assembly, Titrator 3.2.2.94.
│ ├ .Assembly From assembly
│ │ ├ .CyclNo Cycle number ON, OFF 3.2.2.95.
│ │ ├ .V Volume ON, OFF ditto
│ │ ├ .Meas Measured indicator voltage ON, OFF ditto
│ ├ .Titrator From Titrator
│ │ ├ .CyclNo Cycle number ON, OFF 3.2.2.96.
│ │ ├ .V Volume ON, OFF ditto
│ │ ├ .Meas Measured indicator voltage ON, OFF ditto
│ │ ├ .dVdt Volume drift dV/dt ON, OFF ditto
│ │ ├ .dMeasdt Measured value drift ON, OFF ditto
│ │ ├ .dMeasdV 1st deviation of titration curve ON, OFF ditto
│ │ ├ .ERC ERC from DET ON, OFF ditto
│
├ .AutoInfo Automatic message for changes 3.2.2.97.
│ ├ .Status Switch AutoInfo on/off ON, OFF ditto
│ ├ .P When mains is switched on ON, OFF ditto
│ ├ .T Titrator infos
│ │ ├ .R When “ready” ON, OFF ditto
│ │ ├ .G When method started ON, OFF ditto
│ │ ├ .GC When start is initiated ON, OFF ditto
│ │ ├ .S When stopped ON, OFF ditto
│ │ ├ .B Begin of method ON, OFF ditto
│ │ ├ .F End of process ON, OFF ditto