Rockwell Automation 8520-9API 9/Series OCI API Developer's Guide - Manual (Page 232)

OCI Error Handling C–17
Publication 8520-6.6. - August 1999
5300 "VIRTUAL AXIS NOT ALLOWED" 300
5301 "IPD AND G16.3/G16.4 CANNOT BE CONCURRENT"
5302 "WHEEL AXIS MOTION INVALID IN G16.3/G16.4"
5303 "AXIS MOVER CONFLICT WITH G16.3/G16.4"
5304 "SHIFT AWAY FROM ENDPOINT"
5305 "WORK CO-ORD CHANGES NOT ALLOWED" 305
5306 "G26 PLANE INCOMPATABILITY"
5307 "G26 NOT ALLOWED"
5308 "DEPTH PROBE AXIS NOT AMPED"
5309 "DUAL SLAVE OR SPLIT AXIS NOT ALLOWED"
5310 "INVALID AXIS" 310
5311 "FEED TO HARDSTOP PROGRAMMING ERROR"
5312 "ADAPTIVE FEED PRG ERROR"
5313 "G25 PLANE INCOMPATABILITY"
5314 "G25 NOT ALLOWED"
5315 "G24 PLANE INCOMPATABILITY" 315
5316 "G24 NOT ALLOWED"
5317 "AXIS INVALID FOR G24/G25"
5318 "AMPED HOLDING OR DETECT TRQ OUT OF RANGE"
5319 "HARDSTOP AXIS NOT ALLOWED IN INTERRUPT"
5320 "BAD FIRST POCKET BLOCK" 320
5321 "THREAD PULLOUT STOPPED AT I-PLANE"
5322 INCOMPATIBLE TOOL ACTIVATION MODES",
5323 SPINDLE IS CLAMPED",
5324 T-WORD NOT ALLOWED WITH M06",
5325 UNABLE TO SYNC IN CURRENT MODE",
5326 SPINDLE MODES INCOMPATIBLE",
5327 PROGRAMMED SPINDLE UNAVAILABLE",
5328 SPINDLE SYNC NOT CONFIGURED",
5329 RAMP/JERK OUT OF RANGE",
5330 S-CURVE CONFIGURATION ERROR",
5331 ILLEGAL DATA IN ASYNCH MODE",
5332 FIXED CYCLES NOT ALLOWED",
5333 ILLEGAL PRE-BLOCK REQUEST",
5334 ILLEGAL POST-BLOCK REQUEST",
5335 ILLEGAL XFER INHIBIT REQUEST",