MTS SWIFT 10 MC Sensor - Manual (Page 86)

SWIFT 10 MC Sensors 86
Road Simulator
Installing the Transducer
6. Temporarily secure the assembly to the spindle housing using four of the
sixteen M10 fasteners installed 90° from each other.
Lubricate the fasteners and mating surfaces with Molykote g-n paste and
torque, in two equal increments, using a cross pattern to 53 N•m (39 lbf•ft).
7. Assemble the non-slip ring/encoder side as follows (refer to the next figure
during the assembly):
Note The sealed bearings and oil seals shown in the figures have already
been installed in the delivered adapters.
A. If you have not already done so, attach the stock sprocket or brake disk
(as required) to the inner hub/sprocket or brake disk adapter using the
fasteners provided.
Apply Locktite 262 Threadblocker to the screws and torque to the
manufacturers specifications.
B. Apply a little grease or oil to the outer surface of the axle spacer and
insert it into the inner hub adapter from the sprocket or brake disk side.
Push until you feel it snap in place against the bearings.
C. Insert the load spacer from the opposite side.
D. Set this assembly aside.
Spindle
Housing
Transducer
M10 Fasteners
(16)
M8 Fasteners
(20)
S10MC-34
Transducer
(connector side)
Washer
Plate
Adapter
Plate
Spindle
Housing